Trail Armor's Soft Top is made of water-repellent, UV-protected marine grade canvas and binding with 2 fully adjustable loop straps in front and 2 quick-release snap closure buckles rear. It is sewn with marine-quality UV-protected thread. Has bound cut out for rear light. This is a top quality product with a great, tight fit, especially with Limb Bars installed. Will work with or without Trail Armor’s CoolFlo Windshield. Easy on and off, no tools required (once small metal loop strap bars installed on front cage bars). Like all soft tops, it is recommended that you remove and stow this product before trailering your vehicle. Fits the 2006 - 2010 Arctic Cat Prowler 650 H1, 700, XTZ 1000 and 2011 Arctic Cat Prowler HDX (fits only SQUARE TUBE CAGE).

Quick - what is the most common complaint about riding off-road in a side x side vehicle? I’ll bet you said “the DUST”. Install a windshield and roof and you actually compound the problem. In frustration, many have chosen to give up the protection of a windshield altogether rather than be plagued by the dust and heat. After extensive trail testing, Trail Armor has the answer – the CoolFlo Windshield (patent pending). This unique two-piece designdelivers relief from back draft dust while providing superior face and eye protection. As an added benefit, it also helps by reducing cabin temperature. How are CoolFlo windshields different from other shields on the market? To answer this, let’s look at what creates the problem. An open, roll-caged vehicle lets air flow freely while in motion. Put a windshield on the vehicle and the flow of air is changed - a low pressure zone is created behind the windshield. Ever ride in a jeep or convertible car and wonder why your hair blows forward toward the front or windshield? It is because of this low pressure. Automakers have addressed the issue by adding spoilers to roof racks and rear windows to create an air curtain. This works at highway speeds, but the problem still exists at lower trail speeds. It is this low pressure zone that draws the dust into the cab. By simply removing the lower section of the windshield, air is redirected by special foils downward to the floor and backward into the cab, effectively breaking the low pressure zone and forcing trapped engine heat out of the vehicle. The upper portion of the CoolFlo Windshield stays in place for much needed eye and face protection. What if it’s too cold to ride without a full windshield? Leave the bottom part on and take it off later if you need to. Others have tried to fix the dust and heat problem by making half or three-quarter windshields. This only reduces the low-pressure zone; it does not break it. And half windshields do not provide adequate eye protection. So, with a half windshield you have no upper protection, only slightly less dust and the cool air is blown over your head without providing any relief. Trail Armor’s CoolFlo Windshields, made of 1/4" mar-resistant coated polycarbonate (on both the exterior and interior), provide excellent face and eye protection and relieves the dust and heat for a comfortable ride. They are easy to install, and the lower section can be removed and replaced on the fly.Enter coupon code SHIPCOOLFLO to receive free shipping! Retail customers, lower 48 US only. Free shipping can not be combined with any other offer or coupon codes.

Trail Armor's Soft Top is made of water-repellent, UV-protected marine grade canvas and binding with 2 quick-release snap closure buckles front and 2 quick-release snap closure buckles rear. It is sewn with marine-quality UV-protected thread. Has bound cut out for rear light. This is a top quality product with a great, tight fit. Will work with or without Trail Armor’s CoolFlo Windshield. Easy on and off, no tools required (once quick release buckle installed on front cage bars). Like all soft tops, it is recommended that you remove and stow this product before trailering your vehicle. Fits 2011 -2014 1000 XTZ, 550 XT, 700 XTX, 2012 700 HDX round tube cages.

Trail Armor's V-Bags are custom made to fit each vehicles' roll cage cross braces allowing for handy sundry storage on the trail. All bags are 4" deep, zipper close, with velcro straps for easy installation to and removal from your roll cage. Rigid plastic insert on the bag's interior helps maintain bag shape, prevents sagging and puncture on the bottom. This quality bag is made of water-repellent, UV-protected marine grade canvas and binding with Trail Armor logo on front. It is sewn with marine-quality UV-protected thread. Teryx available black only. Grey or Red only in Rhino/Arctic Cat.

Trail Armor's Limb Bars give full side protection to the Arctic Cat Prowler's stock cage to keep limbs and brush from riding over the roll cage and dropping in on top of you and then hanging you up to boot. If you ride in the woods, you know what we are talking about. If you ride in the sand or lightly wooded locations, bars add extra support to your stock roll cage and help keep Soft Top fitting nice and snug. Easy install, requires drilling roll cage for screws. Trail Armor's Prowler Soft Top and Windshield sold separately.  Fits years 2006 - 2011.

With Trail Armor’s half door debris shields and mud guards for the Arctic Cat Prowler, you can enjoy Mother Nature, not wear her. They are made of a 5/8 solid high density plastic and, unlike sheet metal door panels, our door panels will not rust, ding, or bend. Set features stainless steel latches and heavy-duty powder-coated hardware. All exterior fasteners are weather resistant black zinc for a clean finish. A wide 32" swing allows easy in and out while the tight-fitting, slim-line profile allows for navigation in tight spots with nothing to hang on. Installs easily with photo-documented installation instructions. Lightweight and durable, these shields have the factory-like fit and finish that Trail Armor is known for. Fits Arctic Cat 2012 and 2013 700 HDX with BENCH SEAT round tube cage.

Trail Armor's Tool Bags are made of water-repellent, UV-protected marine grade canvas and binding with tote handle. An inner plastic liner helps maintain shape and protects the bag's bottom. It is sewn with marine-quality UV-protected thread. Trail Armor's logo is embroidered on the rear left of the top. Bag straps come with adjustable buckle closures that are easily mounted to your vehicles' flat surfaces via provided footman loops or by screws/pop rivets. These bags can be slipped off mounting straps so you can take it where you need it. Size dimensions: 22 x 8x 6 large, 18 x 6 x 3 medium. Available in red or black.

Install skid plates, axles and a-arms like a pro with Trail Armor’s new Tilt Over Stand! Modeled after the device we use daily in our shop, this tilt over stand will dramatically improve your maintenance and installation woes whenever you need access to your vehicle’s underbelly. Sturdy when in use, our tilt over stand collapses for storage.

Trail Armor's Tool Bags are made of water-repellent, UV-protected marine grade canvas and binding with tote handle. An inner plastic liner helps maintain shape and protects the bag's bottom. It is sewn with marine-quality UV-protected thread. Trail Armor's logo is embroidered on the rear left of the top. Bag straps come with adjustable buckle closures that are easily mounted to your vehicles' flat surfaces via provided footman loops or by screws/pop rivets. These bags can be slipped off mounting straps so you can take it where you need it. Size dimensions: 22 x 8x 6 large, 18 x 6 x 3 medium. Available in black.

Check out Trail Armor's Door Bags. (Set of 2, 1 Driver, 1 Passenger) This bag has an integrated knee pad with added storage for your doors. Will fit ALL Trail Armor's GenX and Slimline doors as well as Trail Armor's Arctic Cat Prowler and Teryx door debris shields. Will also fit RZR XP 1000, 900 XC and 900S factory doors.

Trail Armor's Rear Bumper for the Arctic Cat Prowler mounts easily to the underside of your bed and does not interfere with dumping ability or tailgate function. Built to last of 1 1/4" and 1" tubing and powder coated for extra durability, bumper will accept your choice of lights - up to 2 1/2" x 5" in size. Mounting hardware and simple photo-documented installation instructions are included. Will not fit the 2009 XTZ 1000.

Black powder-coated mount easily installs to roll cage back of your Arctic Cat Prowler (round tube cage) with four U-Bolts. Two air-ride gun racks have cushioning rubber fingers which conform to different gun stock sizes for a snug ride. Rubber straps hold guns in. Does not interfere with dump bed capability. Can also be used to carry bows, fishing rods, shovels, etc. Mounting hardware and installation instructions included. Fits all years with round tube cages. Fits Arctic Cat 700 with round tube cage years 2011- 2013.  Rhino gun rack shown, but installation is the same.