Trail Armor Honda Pioneer 1000 and 1000-5 Full Skids
Get the best in under vehicle protection with Trail Armor's full skid plate set for the Honda Pioneer 1000 and 1000-5. Made from our own custom blend of ultra high molecular weight polymer, these 1/2" plastic skids are lighter than most traditional metal/aluminum skid plates (see specs below) and because they have no "impact memory", they absorb shocks to the bottom of your vehicle without the dents, galling and corrosion of metal/aluminum skids. Trail Armor was the first in the industry to design skids with the formed front leading edges featured on our skid plates. These leading edges protect vulnerable frame edges and wheel wells from blunt edge impacts and act as a starting edge to slide over obstacles without the resistance and drag of metal skid plates. Additionally, these Trail Armor skids for the Honda Pioneer 1000-5 are designed with extended side panels (extend past the rocker panel bottoms about 1/2") that serve as slider nerfs to help protect the vulnerable rocker panels of your vehicle. Compare Trail Armor's skid set coverage with other skid manufacturer's like items - slider nerfs are either sold separately or the bottom skid coverage ends before the rocker panel, leaving this part of your vehicle unprotected. Trail Armor's skid plates come in easy to install panels that cover the full length and breadth of the vehicle, including the front and rear differential. Lap jointed panels create a continuous single smooth sliding surface - not stacked like other manufacturers skids with hard edges to create a catch point. Access holes to service points and oil drains make maintenance a breeze. Strategically placed drain holes allow dirt and debris to wash out - you don't have to remove them to clean out the belly your vehicle. However, if needed, individual panels may be removed to access different areas without removing the entire skid plate. Recessed mounting holes protect fasteners from damaging blows and keeping all bolt heads from protruding the skid's surface. All kits come with corrosion resistant hardware and photo-documented installation instructions. Installation videos, if available, are provided as a YouTube video on our site. SHARED SHIPPING - GET $20.00 off shipping on this product - lower 48 US only. Enter code SHAREDSHIP. Cannot be used with any other coupons.Note: Any Trail Armor a-arm guards shown installed on vehicle in pictures are sold separately and are not included as part of this skid plate set. Shipping weight - skid set 64 lbsFlat 4x8 sheet Aluminum 5052 piece weight, gauge .25: 111.744 lbsFlat 4x8 sheet UHMW piece weight, gauge .5: 79.2576 lbsSource: http://www.onlinemetals.com
Break bad on the trail, ride the most buggy-busting terrain you can find - Trail Armor's new uhmw a-arm guards can take the iMPACT! Made of the same 1 /2" UHMW we make our skid plates out of, these are by far the toughest, best designed and coolest a-arms on the market. Guards have three sided protection of your front and rear CV boots - front, rear and bottom - and mount easily with no drilling required. All mounting hardware and simple photo-documented installation instructions are included.